Desoldering wick 2mm (VEL20E)

A 2 mm desoldering wick is a flat, braided copper wire used to remove solder from PCBs and components by absorbing molten solder through capillary action.

 Key Features

• Width: 2 mm (good general-purpose size)
• Material: Oxygen-free copper braid
• Coating: Pre-fluxed (usually rosin flux)
• Action: Heats up and “wicks” solder into the braid

 What it’s used for

• Cleaning solder off pads
• Removing excess solder
• Fixing solder bridges
• Component removal (IC pins, resistors, etc.)

 2 mm is ideal for:

• Standard PCB work
• Through-hole pads
• Medium-sized SMD pads

How to use it properly

1. Place the wick on the solder joint
2. Press your soldering iron tip on top
3. Wait 1–2 seconds for solder to melt
4. The braid will absorb the solder
5. Lift both together (don’t drag)

Tips for best results

• Add a little extra flux if needed (improves flow)
• Use a clean, hot iron (≈320–370 °C)
• Don’t hold too long — can lift PCB pads
• Cut off used (filled) section before re-using