Advanced 12V battery care for power sport / auto / marine size batteries.
OptiMate 5 VoltMatic can SAVE & CHARGE all 12V lead-acid batteries. Simply connect the charger to the battery, the VoltMatic micro-processor automatically makes the correct charge voltage selection for a healthy* 12V battery and then proceeds to charging. * Manual over-ride for very low voltage 12V batteries is available.
Charge current is regulated according to connected battery size and condition. Leave connected for unsupervised months-long maintenance charging; OptiMate senses the battery condition, delivers charge when needed to keep battery at 100%.
OptiMate 5 saves batteries from as low as 2V and will then charge and maintain the battery, all automatically. Perfect for months-long maintenance of any size 12V lead-acid battery from 8Ah up to 120Ah - deep cycle, automotive, marine, motorcycle....
✷ CHARGING AMPS : 4A (12V) (Ampmatic)
✷ USE : Indoor / Outdoor (lowest temperature: -20ºC).
✷ SAVE : Low Volt Start of 1V + 2-step desulphation recovery.
✷ IDEAL FOR : STD, AGM & GEL 12V batteries from 8 – 120Ah.
✷ INPUT : Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed.
✷ STYLE : Weatherproof case with wall mounts, with 180cm AC supply lead and 180cm charge lead ending in SAE connector. Weatherproof battery lead & standard battery clip set included.
SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected. 3-year limited replacement warranty.
Ideal for 12V lead-acid batteries: 8 to 120Ah, AGM (MF), Standard, GEL and AGM spiral cell
Program control: Microprocessor (9 stages)
Output current (bulk charge): 2.8A (12V)
Automatic desulphation: 3 stage (low voltage 12V battery needs user confirmation)
Charge time limit: 72 hours (maintenance time: unlimited)
Maintain / test cycles: 30 min/30 min (alternating hourly)
Charge retention test: monitors during 30min., no charge intervals
Size: 167 x 65 x 46 mm
Weight (packaging): 0.6 kg
Enclosure classification: fully sealed (IP54), 4 x wall mount tabs
Input cable length: 2m
Output cable length: 2m
Included Accessories: O1 fused eyelet set, weather protected; O4 clamps set for bench charging
Operation temperature range: From -20ºC - 40ºC
Warranty: 2 years
AC supply: 100-240V 50-60Hz 0.90A @ 100-240V
Reverse drain current: less than 0,5mA
Power usage (no battery connected): 0.0089kWh / day
Ratings / approvals : Safety, EMC, Energy efficiency, enclosure seal rating: IP54, CE, NRTL (UL & CSA), SAA (AU & NZ), approved by TUV Sud.
This product was added to our catalog on Friday 15 June, 2012.
